EasyManuals Logo

Cisco Catalyst 2950 Command Reference

Cisco Catalyst 2950
686 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #124 background imageLoading...
Page #124 background image
2-94
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
dot1x default
dot1x default
Use the dot1x default interface configuration command to reset the configurable IEEE 802.1x
parameters to their default values.
dot1x default
Syntax Description This command has no arguments or keywords.
Defaults These are the default values:
The per-interface IEEE 802.1x protocol enable state is disabled (force-authorized).
The number of seconds between re-authentication attempts is 3600 seconds.
The periodic re-authentication is disabled.
The quiet period is 60 seconds.
The retransmission time is 30 seconds.
The maximum retransmission number is 2 times.
The host mode is single host.
The client timeout period is 30 seconds.
The authentication server timeout period is 30 seconds.
Command Modes Interface configuration
Command History
Examples This example shows how to reset the configurable IEEE 802.1x parameters on an interface:
Switch(config-if)# dot1x default
You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC
command.
Related Commands
Release Modification
12.1(6)EA2 This command was introduced.
12.1(14)EA1 This command was changed to the interface configuration mode.
Command Description
show dot1x [interface interface-id] Displays IEEE 802.1x status for the specified interface.

Table of Contents

Other manuals for Cisco Catalyst 2950

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 2950 and is the answer not in the manual?

Cisco Catalyst 2950 Specifications

General IconGeneral
Forwarding Bandwidth8.8 Gbps
Switching Capacity13.6 Gbps
Forwarding Rate6.6 Mpps
Weight3.6 kg
RAM16 MB
Flash Memory8 MB
Operating Humidity10% to 85% non-condensing
Uplink Ports2 x 10/100/1000Base-T
Dimensions4.4 cm x 44.5 cm x 24.2 cm
Remote Management ProtocolSNMP, Telnet, HTTP
FeaturesQuality of Service (QoS), VLAN support
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicatorssystem
Operating Temperature0 to 45°C
Ports24 x 10/100 Ethernet ports
MAC Address Table Size8, 192 entries
Power SupplyInternal 100-240V AC, 50-60Hz

Related product manuals