Cisco Catalyst 2950 Command Reference

2-100
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
dot1x multiple-hosts
dot1x multiple-hosts
This is an obsolete command.
In past releases, the dot1x multiple-hosts interface configuration command was used to allow multiple
hosts (clients) on an IEEE 802.1x-authorized port.
Command History
Related Commands
Release Modification
12.1(6)EA2 This command was introduced.
12.1(14)EA1 The dot1x multiple-hosts interface configuration command was replaced by
the dot1x host-mode interface configuration command.
Command Description
dot1x host-mode Set the IEEE 802.1x host mode on an interface.
show dot1x Displays IEEE 802.1x statistics, administrative status, and operational status
for the switch or for the specified interface.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz