2-422
Catalyst 2950 and Catalyst 2955 Switch Command Reference
0L-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
show vtp
show vtp
Use the show vtp user EXEC command to display general information about the VLAN Trunking
Protocol (VTP) management domain, status, and counters.
show vtp {counters | status} [ | {begin | exclude | include} expression]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show vtp counters command. Table 2-33 describes each field in
the display.
Switch> show vtp counters
VTP statistics:
Summary advertisements received : 38
Subset advertisements received : 0
Request advertisements received : 0
Summary advertisements transmitted : 13
Subset advertisements transmitted : 3
Request advertisements transmitted : 0
Number of config revision errors : 0
Number of config digest errors : 0
Number of V1 summary errors : 0
VTP pruning statistics:
Trunk Join Transmitted Join Received Summary advts received from
non-pruning-capable device
---------------- ---------------- ---------------- ---------------------------
Fa0/1 827 824 0
Fa0/2 827 823 0
Fa0/3 827 823 0
counters Display the VTP statistics for the switch.
status Display general information about the VTP management domain status.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.0(5.2)WC(1) This command was introduced.
To Next Page
Loading...
Need help?
General
