Cisco Catalyst 2950 Command Reference

B-20
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Appendix B Catalyst 2950 and 2955 Switch Boot Loader Commands
rmdir
rmdir
Use the rmdir boot loader command to remove one or more empty directories from the specified file
system.
rmdir filesystem:/directory-url ...
Syntax Description
Command Modes Boot loader
Command History
Usage Guidelines Directory names are case sensitive and limited to 45 characters between the slashes (/); the name cannot
contain control characters, spaces, deletes, slashes, quotes, semicolons, or colons.
Before removing a directory, you must first delete all the files in the directory.
The switch prompts you for confirmation before deleting each directory.
Examples This example shows how to remove a directory:
switch: rmdir flash:Test
You can verify that the directory was deleted by entering the dir filesystem: boot loader command.
Related Commands
filesystem: Alias for a flash file system. Use flash: for the system board flash device.
/directory-url Path (directory) and name of the empty directories to remove. Separate each
directory name with a space.
Release Modification
12.1(11)YJ This command was introduced.
Command Description
dir Displays a list of files and directories on the specified file system.
mkdir Creates one or more new directories on the specified file system.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz