2-312
Catalyst 2950 and Catalyst 2955 Switch Command Reference
0L-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
show controllers lre sequence
show controllers lre sequence
Use the show controllers lre sequence privileged EXEC command to display the list of sequences, the
profiles that are configured in that sequence, and the downstream and upstream rates of the
corresponding profiles.
show controllers lre sequence [ | {begin | exclude | include} expression]
This command is available only on Catalyst 2950 LRE switches.
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines Use the show controllers lre sequence command to display the list of sequences supported in the
switch. This command displays the system-defined and user-defined sequences.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show controllers lre sequence command on the
Catalyst 2950ST-8 LRE and 2950ST-24 LRE switches:
Switch# show controllers lre sequence
Global Sequence:LRE-SEQ-COMPLETE-REACH
Sequence:LRE-SEQ-COMPLETE-REACH Type:System-Configured
Profile Name Downstream Upstream
Rate(Mbps) Rate(Mbps)
-------------- ---------- ----------
LRE-15 16.667 18.750
LRE-10 12.500 12.500
LRE-15-5 16.667 6.250
LRE-10-5 12.500 6.250
LRE-8 9.375 9.375
LRE-7 8.333 8.333
LRE-15-3 16.667 3.125
LRE-10-3 12.500 3.125
LRE-5 6.250 6.250
LRE-15-1 16.667 1.563
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.1(11)YJ This command was introduced.
To Next Page
Loading...
Need help?
General
