Cisco Catalyst 2950 Command Reference

2-44
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
clear interface
clear interface
Use the clear interface privileged EXEC command to clear the hardware logic on an interface
or a VLAN.
clear interface {interface-id | vlan vlan-id}
Syntax Description
Defaults No default is defined.
Command Modes Privileged EXEC
Command History
Examples This example shows how to clear the hardware logic on an interface:
Switch# clear interface gigabitethernet0/1
This example shows how to clear the hardware logic on a specific VLAN:
Switch# clear interface vlan 5
You can verify that the interface-reset counter for an interface is incremented by entering the show
interfaces privileged EXEC command.
interface-id ID of the interface.
vlan-id VLAN ID. The range is 1 to 4094.
Release Modification
12.1(6)EA2 This command was introduced.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz