C-4
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Appendix C Catalyst 2950 and 2955 Switch Debug Commands
debug dot1x
debug dot1x
Use the debug dot1x privileged EXEC command to enable debugging of the IEEE 802.1x authentication
feature. Use the no form of this command to disable debugging.
debug dot1x {all | errors | events | packets | registry | state-machine}
no debug dot1x {all | errors | events | packets | registry | state-machine}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug dot1x command is the same as the no debug dot1x command.
Related Commands
all Display all IEEE 802.1x authentication debug messages.
errors Debug IEEE 802.1x error debug messages.
events Debug IEEE 802.1x event debug messages.
packets Debug IEEE 802.1x packet debug messages.
registry Debug registry invocation debug messages.
state-machine Debug state-machine related-events debug messages.
Release Modification
12.1(6)EA2 This command was introduced.
12.1(14)EA1 The authsm, backend, besm, core, and reauthsm keywords were removed.
The errors, events, packets registry, and state-machine keywords were
added.
Command Description
show debugging Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Configuration Fundamentals
Command Reference for IOS Release 12.1 > Cisco IOS System
Management Commands > Troubleshooting Commands.
show dot1x Displays IEEE 802.1x statistics, administrative status, and operational status
for the switch or for the specified interface.
To Next Page
Loading...
Need help?
General
