2-375
Catalyst 2950 and Catalyst 2955 Switch Command Reference
0L-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
show mls masks
show mls masks
Use the show mls masks user EXEC command to display the details of the access control parameters
(ACPs) used for quality of service (QoS) and security access control lists (ACLs).
show mls masks [qos | security] [ | {begin | exclude | include} expression]
This command is available only if your switch is running the enhanced software image (EI).
Syntax Description
Note ACPs are called masks in the command-line interface (CLI) commands and output.
Command Modes User EXEC
Command History
Usage Guidelines Use the show mls masks command without keywords to display all ACPs configured on the switch.
Use this command with the qos keyword to display the ACPs used for QoS ACLs.
Use this command with the security keyword to display the ACPs used for security ACLs.
Note You can configure up to four ACPs (QoS and security) on a switch.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
qos (Optional) Display ACPs used for QoS ACLs.
security (Optional) Display ACPs used for security ACLs.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.1(6)EA2 This command was introduced.
To Next Page
Loading...
Need help?
General
