A-4
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Appendix A Catalyst 2955 Alarm Commands
alarm facility temperature
alarm facility temperature
Use the alarm facility temperature global configuration command to configure a primary temperature
monitoring alarm or to configure a secondary temperature alarm threshold with a lower maximum
temperature threshold. Use the no form of this command to delete the temperature monitoring alarm
configuration or to disable the secondary temperature alarm.
alarm facility temperature {primary {notifies | relay {major | minor} | syslog} | secondary
{threshold | notifies | relay {major | minor}| syslog}}
no alarm facility temperature {primary {notifies | relay {major | minor} | syslog} | secondary
{threshold | notifies | relay {major | minor}| syslog}}
Syntax Description
Defaults The primary temperature alarm is enabled for a -20 to 95
o
C range and cannot be deleted. It is associated
with a major relay. The secondary temperature alarm is disabled by default.
Command Modes Global configuration
Command History
Usage Guidelines The primary temperature alarm is automatically enabled. It cannot be disabled, but you can configure
alarm options.
You can use the secondary temperature alarm to trigger a high temperature alarm at lower than the
maximum primary temperature threshold (95
o
C). You can configure the temperature threshold and alarm
options.
Before you use the notifies keyword to sent alarm traps to an SNMP host, you need to set up an SNMP
server by using the snmp-server enable traps global configuration command.
threshold Set a lower high temperature threshold for the secondary temperature alarm in
degrees C. The allowable range is 40 to 95
o
C.
notifies Send primary or secondary temperature alarm traps to a Simple Network
Management Protocol (SNMP) server.
relay major Send the primary or secondary temperature alarm to the major relay circuitry.
relay minor Send the primary or secondary temperature alarm to the minor relay circuitry.
syslog Send primary or secondary temperature alarm traps to a syslog server.
Release Modification
12.1(12c)EA1 This command was introduced.
To Next Page
Loading...
Need help?
General
