Cisco Catalyst 2950 Command Reference

Contents
iv
Catalyst 2950 and Catalyst 2955 Switch Command Reference
78-11381-12
aaa authentication dot1x 2-3
access-list (IP extended) 2-5
access-list (IP standard) 2-8
archive download-sw 2-10
archive tar 2-12
archive upload-sw 2-15
auto qos voip 2-17
boot boothlpr 2-21
boot buffersize 2-22
boot config-file 2-23
boot enable-break 2-24
boot helper 2-25
boot helper-config-file 2-26
boot manual 2-27
boot private-config-file 2-28
boot system 2-29
channel-group 2-30
channel-protocol 2-33
class 2-35
class-map 2-37
clear controllers ethernet-controller 2-39
clear controllers lre 2-41
clear controllers lre link monitor 2-42
clear controllers lre log 2-43
clear interface 2-44
clear lacp 2-45
clear lre rate selection 2-46
clear mac address-table 2-47
clear pagp 2-49
clear port-security 2-50
clear spanning-tree counters 2-53
clear spanning-tree detected-protocols 2-54
clear vmps statistics 2-55
clear vtp counters 2-56
cluster commander-address 2-57

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz