EasyManuals Logo

Cisco Catalyst 2950 Command Reference

Cisco Catalyst 2950
686 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #151 background imageLoading...
Page #151 background image
2-121
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
interface
interface
Use the interface global configuration command to configure an interface type, create a switch virtual
interface to be used as the management VLAN interface, and to enter interface configuration mode.
interface {interface-id | vlan number}
no interface {interface-id | vlan number}
Syntax Description
Defaults The default management VLAN interface is VLAN 1.
Command Modes Global configuration
Command History
Usage Guidelines When creating a management VLAN interface, a space between vlan and number is accepted.
Only one management VLAN interface can be active.
You cannot delete the management VLAN 1 interface.
You can use the no shutdown interface configuration command to shut down the active management
VLAN interface and to enable a new one.
You can configure the management VLAN interface on static-access and trunk ports.
Examples This example shows how enter interface configuration mode for an interface:
Switch(config)# interface fastethernet0/2
Switch(config-if)#
This example shows how to change the management VLAN from the default management VLAN to
VLAN 3. This series of commands should only be entered from the service port. If these commands are
entered through a Telnet session, the shutdown command disconnects the session, and there is no way
to use IP to access the system.
Switch# configure terminal
Switch(config)# interface vlan 3
Switch(config-if)# ip address 172.20.128.176 255.255.255.0
Switch(config-if)# no shutdown
Switch(config-if)# exit
You can verify your settings by entering the show interfaces and show interfaces vlan vlan-id
privileged EXEC commands.
interface-id Specify the interface type and number.
vlan number VLAN number from 1 to 4094 to be used as the management VLAN.
Release Modification
12.0(5.2)WC(1) This command was introduced.

Table of Contents

Other manuals for Cisco Catalyst 2950

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 2950 and is the answer not in the manual?

Cisco Catalyst 2950 Specifications

General IconGeneral
Forwarding Bandwidth8.8 Gbps
Switching Capacity13.6 Gbps
Forwarding Rate6.6 Mpps
Weight3.6 kg
RAM16 MB
Flash Memory8 MB
Operating Humidity10% to 85% non-condensing
Uplink Ports2 x 10/100/1000Base-T
Dimensions4.4 cm x 44.5 cm x 24.2 cm
Remote Management ProtocolSNMP, Telnet, HTTP
FeaturesQuality of Service (QoS), VLAN support
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicatorssystem
Operating Temperature0 to 45°C
Ports24 x 10/100 Ethernet ports
MAC Address Table Size8, 192 entries
Power SupplyInternal 100-240V AC, 50-60Hz

Related product manuals