2-252
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
rate selection profile lock
rate selection profile lock
Use the rate selection profile lock interface configuration command to lock a profile in a port on
which rate selection is enabled. Use the no form of this command to unlock a profile in a port.
rate selection profile lock
no rate selection profile lock
This command is available only on Catalyst 2950 Long-Reach Ethernet (LRE) switches.
Syntax Description This command has no arguments or keywords.
Command Modes Interface configuration
Command History
Usage Guidelines The rate selection profile lock interface configuration command does not enable rate selection. It only
takes affect when a sequence is assigned to a port.
If rate selection is already converged on the port, this command causes the profile chosen by rate
selection to immediately lock. During the lock process, the name of the profile appends to the end of this
command. For example, if rate selection converges on LRE-15 and you enter the command, this locked
configuration appears:
Switch(config-if)# rate selection profile lock LRE-15
If rate selection is not already converged on the port, this command has no immediate effect. However,
when rate selection converges for that port, the profile is locked immediately, and the output of the
running configuration is saved as in the previous example.
Examples This example shows how to lock a profile to a port that is running rate selection:
Switch(config-if)# rate selection profile lock
Release Modification
12.1(11)YJ This command was introduced.
To Next Page
Loading...
Need help?
General
