2-249
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
profile (sequence configuration)
profile (sequence configuration)
Use the profile sequence configuration command to add a Long-Reach Ethernet (LRE) profile to a
sequence. Use the no form of this command to delete a profile from the sequence.
profile profile-name
no profile profile-name
This command is available only on Catalyst 2950 LRE switches.
Syntax Description
Defaults The default profile is LRE-10.
Command Modes Sequence configuration
Command History
Usage Guidelines When you add an LRE profile to a sequence, the profile is added as in a FIFO queue. Rate selection
attempts to establish a link with the first profile in the sequence. If the link is not established in that
profile, rate selection uses the next profile in the queue.
You cannot add a profile in the middle of the sequence. To add a profile to a user-defined sequence in
the middle of a sequence, you need to delete the most recent profiles first.
Although you can delete a profile from a sequence, you cannot change a sequence’s configuration if it
is in use by an interface.
You cannot add or delete a profile from a system-defined sequence.
For more information about using LRE profiles and profile sequences, see the “LRE Links and LRE
Profiles” section in the switch software configuration guide for this release.
Examples This example shows how to assign the LRE-4 profile to the seq2downsym sequence:
Switch(config)# lre sequence seq2downsym
Switch(config-seq)# profile lre-4
profile-name Name of the profile. The profile name can be a Cisco-supplied profile or a
user-created profile. For more information, see the switch software
configuration guide for this release.
Release Modification
12.1(11)YJ This command was introduced.
To Next Page
Loading...
Need help?
General
