Cisco Catalyst 2950 Command Reference

A-21
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Appendix A Catalyst 2955 Alarm Commands
test relay
test relay
Use the test relay privileged EXEC command to turn on or off the relay circuitry.
test relay {major | minor} {on| off}
Caution Using the test command alters the state (on or off) of a relay. Previous states are not saved.
Command Modes Privileged EXEC
Command History
Usage Guidelines You can use the test relay privileged EXEC command to check relay circuitry connections to the alert
devices. The command provides a way to test alarm scanners without having to create an alarm
condition.
Examples This example shows how to turn on the major relay circuitry:
Switch# test relay major on
Related Commands
Release Modification
12.1(12c)EA1 This command was introduced.
Command Description
show alarm profile Displays all alarm profiles or a specified alarm profile and lists the
interfaces to which each profile is attached.
show alarm settings Displays environmental alarm settings and options.
show facility-alarm relay Displays alarm relays generated on the switch.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz