Cisco Catalyst 2950

B-19
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Appendix B Catalyst 2950 and 2955 Switch Boot Loader Commands
reset
reset
Use the reset boot loader command to perform a hard reset on the system. A hard reset is similar to
power-cycling the switch, clearing the processor, registers, and memory.
reset
Syntax Description This command has no arguments or keywords.
Command Modes Boot loader
Command History
Examples This example shows how to reset the system:
switch: reset
Are you sure you want to reset the system (y/n)?y
System resetting...
Related Commands
Release Modification
12.1(11)YJ This command was introduced.
Command Description
boot Loads and boots an executable image and enters the command-line interface.