EasyManuals Logo

Cisco Catalyst 2950 Command Reference

Cisco Catalyst 2950
686 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #668 background imageLoading...
Page #668 background image
C-28
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Appendix C Catalyst 2950 and 2955 Switch Debug Commands
debug udld
debug udld
Use the debug udld privileged EXEC command to enable debugging of the UniDirectional Link
Detection (UDLD) feature. Use the no form of this command to disable UDLD debugging.
debug udld {events | packets | registries}
no debug udld {events | packets | registries}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines For debug udld events, these debugging messages appear:
General UDLD program logic flow
State machine state changes
Program actions for the set and clear ErrDisable state
Neighbor cache additions and deletions
Processing of configuration commands
Processing of link-up and link-down indications
For debug udld packets, these debugging messages appear:
General packet processing program flow on receipt of an incoming packet
Indications of the contents of the various pieces of packets received (such as type length versions
[TLVs]) as they are examined by the packet reception code
Packet transmission attempts and the outcome
events Display debug messages for UDLD process events as they occur.
packets Display debug messages for the UDLD process as it receives packets from the packet
queue and tries to send them at the request of the UDLD protocol code.
registries Display debug messages for the UDLD process as it processes registry calls from the
UDLD process-dependent module and other feature modules.
Release Modification
12.1(6)EA2 This command was introduced.

Table of Contents

Other manuals for Cisco Catalyst 2950

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 2950 and is the answer not in the manual?

Cisco Catalyst 2950 Specifications

General IconGeneral
Forwarding Bandwidth8.8 Gbps
Switching Capacity13.6 Gbps
Forwarding Rate6.6 Mpps
Weight3.6 kg
RAM16 MB
Flash Memory8 MB
Operating Humidity10% to 85% non-condensing
Uplink Ports2 x 10/100/1000Base-T
Dimensions4.4 cm x 44.5 cm x 24.2 cm
Remote Management ProtocolSNMP, Telnet, HTTP
FeaturesQuality of Service (QoS), VLAN support
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicatorssystem
Operating Temperature0 to 45°C
Ports24 x 10/100 Ethernet ports
MAC Address Table Size8, 192 entries
Power SupplyInternal 100-240V AC, 50-60Hz

Related product manuals