Cisco Catalyst 2950 Command Reference

2-200
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
macro description
macro description
Use the macro description interface configuration command to enter a description about which macros
are applied to an interface. Use the no form of this command to remove the description.
macro description text
no macro description text
Syntax Description
Defaults This command has no default setting.
Command Modes Interface configuration
Command History
Usage Guidelines Use the description keyword to associate comment text, or the macro name, with an interface. When
multiple macros are applied on a single interface, the description text will be from the last applied macro.
This example shows how to add a description to an interface:
Switch(config-if)# macro description duplex settings
You can verify your settings by entering the show parser macro description privileged EXEC
command.
Related Commands
description text Enter a description about the macros that are applied to the specified interface.
Release Modification
12.1(19)EA1 This command was introduced.
Command Description
macro apply Applies a macro on an interface or applies and traces a macro on an
interface.
macro global Applies a macro on a switch or applies and traces a macro on a switch
macro global
description
Adds a description about the macros that are applied to the switch.
macro name Creates a macro.
show parser macro Displays the macro definition for all macros or for the specified macro.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz