EasyManuals Logo

Cisco Catalyst 2950 Command Reference

Cisco Catalyst 2950
686 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #197 background imageLoading...
Page #197 background image
2-167
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
link monitor logging
link monitor logging
Use the link monitor logging interface configuration command to enable Long-Reach Ethernet (LRE)
link monitoring event logging. Use the no form of this command to disable LRE link monitor logging.
link monitor logging
no link monitor logging
This command is available only on Catalyst 2950 LRE switches.
Syntax Description This command has no arguments or keywords.
Defaults LRE link monitoring event logging is disabled.
Command Modes Interface configuration
Command History
Usage Guidelines Events are logged in the system log when a configured threshold is crossed.
Examples This example shows how to enable LRE link monitoring logging on an LRE port:
Switch# configure terminal
Switch(config)# interface longreachethernet0/2
Switch(config-if)# link monitor logging
Command History
Release Modification
12.1(11)YJ This command was introduced.
Command Description
clear controllers lre link monitor Deletes LRE link monitor data.
link monitor Enables the LRE link monitor on a port.
link monitor threshold snr Sets a signal-to-noise margin for the LRE link monitor.
link monitor threshold rserr Sets a Reed-Solomon error threshold for the LRE link monitor.
show controllers lre link monitor Displays the LRE link monitor information.

Table of Contents

Other manuals for Cisco Catalyst 2950

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 2950 and is the answer not in the manual?

Cisco Catalyst 2950 Specifications

General IconGeneral
Forwarding Bandwidth8.8 Gbps
Switching Capacity13.6 Gbps
Forwarding Rate6.6 Mpps
Weight3.6 kg
RAM16 MB
Flash Memory8 MB
Operating Humidity10% to 85% non-condensing
Uplink Ports2 x 10/100/1000Base-T
Dimensions4.4 cm x 44.5 cm x 24.2 cm
Remote Management ProtocolSNMP, Telnet, HTTP
FeaturesQuality of Service (QoS), VLAN support
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicatorssystem
Operating Temperature0 to 45°C
Ports24 x 10/100 Ethernet ports
MAC Address Table Size8, 192 entries
Power SupplyInternal 100-240V AC, 50-60Hz

Related product manuals