2-46
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
clear lre rate selection
clear lre rate selection
Use the clear lre rate selection privileged EXEC command to reset the current rate selection setting and
to restart rate selection for a specific Long-Reach Ethernet (LRE) port or for all switch LRE ports.
clear lre rate selection [lock] [interface-id]
This command is available only on Catalyst 2950 LRE switches.
Syntax Description
Defaults No default is defined.
Command Modes Privileged EXEC
Command History
Usage Guidelines If you enter the lock keyword or specify an interface, the switch runs rate selection on all LRE switch
ports that have rate selection enabled, except those ports with locked profiles. If you enter the lock
keyword, the switch runs rate selection on all profiles, including those that are locked.
Examples This example shows how to reset the rate selection setting and to restart rate selection on an LRE port:
Switch# clear lre rate selection longreachethernet0/1
This example shows how to rerun rate selection on all ports, including any locked ports:
Switch# clear lre rate selection lock
This example shows how to reset and to restart rate selection on an LRE port, overriding the locked
status:
Switch# clear lre rate selection lock longreachethernet0/2
Related Commands
lock (Optional) Rate selection runs on all ports that have rate selection enabled,
including ports that are locked.
interface-id (Optional) ID of an LREs witch port.
Release Modification
12.1(11)YJ This command was introduced.
Command Description
rate selection Enables rate selection on an LRE specific port
rate selection sequence Assigns a rate selection sequence for a specific LRE port.
lre rate selection sequence Assigns a rate selection sequence for the entire LRE switch.
To Next Page
Loading...
Need help?
General
