Cisco Catalyst 2950 Command Reference

2-498
Catalyst 2950 and Catalyst 2955 Switch Command Reference
0L-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
switchport nonegotiate
switchport nonegotiate
Use the switchport nonegotiate interface configuration command to specify that Dynamic Trunking
Protocol (DTP) negotiation packets are not sent on the Layer 2 interface. The switch does not engage in
DTP negotiation on this interface. Use the no form of this command to return to the default setting.
switchport nonegotiate
no switchport nonegotiate
Syntax Description This command has no arguments or keywords.
Defaults The default is to use DTP negotiation to determine trunking status.
Command Modes Interface configuration
Command History
Usage Guidelines The no form of the switchport nonegotiate command removes nonegotiate status.
This command is valid only when the interface switchport mode is access or trunk (configured by using
the switchport mode access or the switchport mode trunk interface configuration command). This
command returns an error if you attempt to execute it in dynamic (auto or desirable) mode.
Internetworking devices that do not support DTP might forward DTP frames improperly and cause
misconfigurations. To avoid this, you should turn off DTP by using the switchport no negotiate
command to configure the interfaces connected to devices that do not support DTP to not forward DTP
frames.
When you enter the switchport nonegotiate command, DTP negotiation packets are not sent on the
interface. The device does or does not trunk according to the mode parameter given: access or trunk.
• If you do not intend to trunk across those links, use the switchport mode access interface
configuration command to disable trunking.
• To enable trunking ona device that does not support DTP, use the switchport mode trunk and
switchport nonegotiate interface configuration commands to cause the interface to become a trunk
but to not generate DTP frames.
Note On GigaStack GBICs, dynamic trunking is supported only when one port of a GigaStack GBIC is being
used. If trunking is required on a GigaStack GBIC where both ports are in use, use the switchport mode
trunk and switchport nonegotiate interface configuration commands on both GBIC interfaces to cause
the interfaces to become trunks.
Release Modification
12.1(6)EA2 This command was introduced.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz