Cisco Catalyst 2950 Command Reference

2-64
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
cluster run
cluster run
Use the cluster run global configuration command to enable clustering on a switch. Use the no form of
this command to disable clustering on a switch.
cluster run
no cluster run
Defaults Clustering is enabled on all switches.
Command Modes Global configuration
Command History
Usage Guidelines When you enter the no cluster run command on a command switch, the command switch is disabled.
Clustering is disabled, and the switch cannot become a candidate switch.
When you enter the no cluster run command on a member switch, it is removed from the cluster.
Clustering is disabled, and the switch cannot become a candidate switch.
When you enter the no cluster run command on a switch that is not part of a cluster, clustering is
disabled on this switch. This switch cannot then become a candidate switch.
Examples This example shows how to disable clustering on the command switch:
Switch(config)# no cluster run
You can verify that clustering is disabled by entering the show cluster privileged EXEC command.
Related Commands
Release Modification
12.0(5.2)WC(1) This command was introduced.
Command Description
show cluster Displays the cluster status and a summary of the cluster to which the switch
belongs.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz