EasyManuals Logo

Cisco Catalyst 2950 Command Reference

Cisco Catalyst 2950
686 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #300 background imageLoading...
Page #300 background image
2-272
Catalyst 2950 and Catalyst 2955 Switch Command Reference
0L-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
show auto qos
show auto qos
Use the show auto qos user EXEC command to display the quality of service (QoS) commands entered
on the interfaces on which automatic QoS (auto-QoS) is enabled.
show auto qos [interface [interface-id]]
This command is available only if your switch is running the enhanced software image (EI).
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines In releases earlier than Cisco IOS Release 12.1(20)EA2, the show auto qos [interface [interface-id]]
command output shows the initial generated auto-QoS configuration.
In Cisco IOS Release 12.1(20)EA2 or later, the show auto qos command output shows only the
auto-QoS command entered on each interface. The show auto qos interface interface-id command
output shows the auto-QoS command entered on a specific interface.
Use the show running-config privileged EXEC command to display the auto-QoS configuration and the
user modifications.
To display information about the QoS configuration that might be affected by auto-QoS, use one of these
commands:
show mls qos
show mls qos map cos-dscp
show mls qos interface
show running-config
show wrr-queue bandwidth
show wrr-queue cos-map
interface [interface-id] (Optional) Display auto-QoS information for the specified
interface or for all interfaces. Valid interfaces include physical
ports.
Release Modification
12.1(12c)EA1 This command was introduced.
12.1(20)EA2 The information in the command output changed, and the user guidelines
were updated.

Table of Contents

Other manuals for Cisco Catalyst 2950

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 2950 and is the answer not in the manual?

Cisco Catalyst 2950 Specifications

General IconGeneral
Forwarding Bandwidth8.8 Gbps
Switching Capacity13.6 Gbps
Forwarding Rate6.6 Mpps
Weight3.6 kg
RAM16 MB
Flash Memory8 MB
Operating Humidity10% to 85% non-condensing
Uplink Ports2 x 10/100/1000Base-T
Dimensions4.4 cm x 44.5 cm x 24.2 cm
Remote Management ProtocolSNMP, Telnet, HTTP
FeaturesQuality of Service (QoS), VLAN support
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicatorssystem
Operating Temperature0 to 45°C
Ports24 x 10/100 Ethernet ports
MAC Address Table Size8, 192 entries
Power SupplyInternal 100-240V AC, 50-60Hz

Related product manuals