Cisco Catalyst 2950 Command Reference

2-383
Catalyst 2950 and Catalyst 2955 Switch Command Reference
0L-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
show mvr
show mvr
Use the show mvr privileged EXEC command without keywords to display the Multicast VLAN
Registration (MVR) global parameter values, including whether or not MVR is enabled, the MVR
multicast VLAN, the maximum query response time, the number of multicast groups, and the MVR
mode (dynamic or compatible).
show mvr [ | {begin | exclude | include} expression]
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show mvr command:
Switch# show mvr
MVR Running: TRUE
MVR multicast vlan: 1
MVR Max Multicast Groups: 256
MVR Current multicast groups: 256
MVR Global query response time: 5 (tenths of sec)
MVR Mode: compatible
In the previous example, the maximum number of multicast groups is 256. The MVR mode is either
compatible (for interoperability with Catalyst 2900 XL and Catalyst 3500 XL switches) or dynamic
(where operation is consistent with Internet Group Management Protocol [IGMP] snooping operation,
and dynamic MVR membership on source ports is supported).
Related Commands
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.1(6)EA2 This command was introduced.
Command Description
mvr Enables and configures multicast VLAN registration on the switch.
mvr type Configures an MVR port as a receiver or a source port.
show mvr interface Displays the configured MVR interfaces, status of the specified interface, or
all multicast groups to which the interface belongs.
show mvr members Displays all ports that are members of an MVR multicast group.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz