Cisco Catalyst 2950 Command Reference

2-197
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
macro apply
macro apply
Use the macro apply interface configuration command to apply a macro to an interface or to apply and
trace a macro configuration on an interface.
macro {apply | trace} macro-name [parameter {value}] [parameter {value}]
[parameter {value}]
Syntax Description
Defaults This command has no default setting.
Command Modes Interface configuration
Command History
Usage Guidelines You can use the macro trace macro-name interface configuration command to apply and show the
macros running on an interface or to debug the macro to find any syntax or configuration errors.
If a command fails because of a syntax error or a configuration error when you apply a macro, the macro
continues to apply the remaining commands to the interface.
When creating a macro that requires the assignment of unique values, use the parameter value keywords
to designate values specific to the interface.
Keyword matching is case sensitive. All matching occurrences of the keyword are replaced with the
corresponding value. Any full match of a keyword, even if it is part of a larger string, is considered a
match and is replaced by the corresponding value.
Some macros might contain keywords that require a parameter value. You can use the macro apply
macro-name ? command to view a list of any required values in the macro. If you apply a macro without
entering the keyword values, the commands are invalid and are not applied.
There are Cisco-default Smartports macros embedded in the switch software. You can display these
macros and the commands they contain by using the show parser macro user EXEC command.
apply Apply a macro to the specified interface.
trace Use the trace keyword to apply a macro to an interface and to debug the macro.
macro-name Specify the name of the macro.
parameter value (Optional) Specify unique parameter values that are specific to the interface. You
can enter up to three keyword-value pairs. Parameter keyword matching is case
sensitive. All matching occurrences of the keyword are replaced with the
corresponding value.
Release Modification
12.1(19)EA1 This command was introduced.
12.1(20)EA1 The parameter value keywords were added.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz