Cisco Catalyst 2950

2-323
Catalyst 2950 and Catalyst 2955 Switch Command Reference
0L-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
show dot1x
Switch# show dot1x all
Dot1x Info for interface FastEthernet 0/3
----------------------------------------------------
Supplicant MAC 00d0.b71b.35de
AuthSM State = CONNECTING
BendSM State = IDLE
PortStatus = UNAUTHORIZED
MaxReq = 2
HostMode = Single
Port Control = Auto
QuietPeriod = 60 Seconds
Re-authentication = Disabled
ReAuthPeriod = 3600 Seconds
ServerTimeout = 30 Seconds
SuppTimeout = 30 Seconds
TxPeriod = 30 Seconds
Guest-Vlan = 0
Dot1x Info for interface FastEthernet 0/7
----------------------------------------------------
PortStatus = UNAUTHORIZED
MaxReq = 2
HostMode = Multi
Port Control = Auto
QuietPeriod = 60 Seconds
Re-authentication = Disabled
ReAuthPeriod = 3600 Seconds
ServerTimeout = 30 Seconds
SuppTimeout = 30 Seconds
TxPeriod = 30 Seconds
Guest-Vlan = 0
This is an example of output from the show dot1x all privileged EXEC command when a restricted
VLAN is configured:
Switch# show dot1x all
Dot1x Info for interface GigabitEthernet0/1
----------------------------------------------------
Supplicant MAC 0002.b3eb.0df6
AuthSM State = AUTHENTICATED(AUTH-FAIL-VLAN)
BendSM State = IDLE
Posture = N/A
PortStatus = AUTHORIZED(AUTH-FAIL-VLAN)
MaxReq = 2
MaxAuthReq = 2
HostMode = Single
PortControl = Auto
ControlDirection = Both
QuietPeriod = 10 Seconds
Re-authentication = Disabled
ReAuthPeriod = 3600 Seconds
ServerTimeout = 30 Seconds
SuppTimeout = 30 Seconds
TxPeriod = 10 Seconds
Guest-Vlan = 3
AuthFail-Vlan = 4
AuthFail-Max-Attempts = 3
This is an example of output from the show dot1x interface fastethernet0/3 privileged EXEC
command:
Switch# show dot1x interface fastethernet0/3
Supplicant MAC 00d0.b71b.35de
AuthSM State = AUTHENTICATED (AUTH-FAIL-VLAN)