Cisco Catalyst 2950 Command Reference

B-18
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Appendix B Catalyst 2950 and 2955 Switch Boot Loader Commands
rename
rename
Use the rename boot loader command to rename a file.
rename filesystem:/source-file-url filesystem:/destination-file-url
Syntax Description
Command Modes Boot loader
Command History
Usage Guidelines Filenames and directory names are case sensitive.
Directory names are limited to 45 characters between the slashes (/); the name cannot contain control
characters, spaces, deletes, slashes, quotes, semicolons, or colons.
Filenames are limited to 45 characters; the name cannot contain control characters, spaces, deletes,
slashes, quotes, semicolons, or colons.
Examples This example shows a file named config.text being renamed to config1.text:
switch: rename flash:config.text flash:config1.text
You can verify that the file was renamed by entering the dir filesystem: boot loader command.
Related Commands
filesystem: Alias for a flash file system. Use flash: for the system board flash device.
/source-file-url Original path (directory) and filename.
/destination-file-url New path (directory) and filename.
Release Modification
12.1(11)YJ This command was introduced.
Command Description
copy Copies a file from a source to a destination.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz