EasyManuals Logo

Cisco Catalyst 2950 Command Reference

Cisco Catalyst 2950
686 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #129 background imageLoading...
Page #129 background image
2-99
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
dot1x max-req
dot1x max-req
Use the dot1x max-req interface configuration command to set the maximum number of times that the
switch sends an Extensible Authentication Protocol (EAP) frame from the authentication server
(assuming that no response is received) to the client before restarting the authentication process. Use the
no form of this command to return to the default setting.
dot1x max-req count
no dot1x max-req
Syntax Description
Defaults The default is 2.
Command Modes Interface configuration
Command History
Usage Guidelines You should change the default value of this command only to adjust for unusual circumstances such as
unreliable links or specific behavioral problems with certain clients and authentication servers.
Examples This example shows how to set 5 as the number of times that the switch sends an EAP frame before
restarting the authentication process:
Switch(config-if)# dot1x max-req 5
You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC
command.
Related Commands
count Number of times that the switch sends an EAP frame from the authentication
server before restarting the authentication process. The range is 1 to 10.
Release Modification
12.1(6)EA2 This command was introduced.
12.1(14)EA1 This command was changed to the interface configuration mode.
Command Description
dot1x timeout Sets the number of seconds that the switch waits for a response to an
EAP-request/identity frame from the client before resending the
request.
show dot1x [interface
interface-id]
Displays IEEE 802.1x status for the specified interface.

Table of Contents

Other manuals for Cisco Catalyst 2950

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 2950 and is the answer not in the manual?

Cisco Catalyst 2950 Specifications

General IconGeneral
Forwarding Bandwidth8.8 Gbps
Switching Capacity13.6 Gbps
Forwarding Rate6.6 Mpps
Weight3.6 kg
RAM16 MB
Flash Memory8 MB
Operating Humidity10% to 85% non-condensing
Uplink Ports2 x 10/100/1000Base-T
Dimensions4.4 cm x 44.5 cm x 24.2 cm
Remote Management ProtocolSNMP, Telnet, HTTP
FeaturesQuality of Service (QoS), VLAN support
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicatorssystem
Operating Temperature0 to 45°C
Ports24 x 10/100 Ethernet ports
MAC Address Table Size8, 192 entries
Power SupplyInternal 100-240V AC, 50-60Hz

Related product manuals