Cisco Catalyst 2950 Command Reference

2-251
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
rate selection
rate selection
Use the rate selection interface configuration command to enable rate selection on a port. Use the no
form of this command to disable rate selection on the port.
rate selection
no rate selection
This command is available only on Catalyst 2950 Long-Reach Ethernet (LRE) switches.
Syntax Description This command has no arguments or keywords.
Defaults Rate selection is enabled on all interfaces.
Command Modes Interface configuration
Command History
Usage Guidelines Use the rate selection interface configuration command to enable rate selection on a port. This
command does not start rate selection. To start rate selection, assign a sequence to a port by using the
rate selection sequence interface configuration command or the lre rate selection sequence global
configuration command.
If a global sequence is configured and rate selection is disabled on a port, rate selection runs on all switch
ports except the port on which rate selection is disabled.
Examples This example disables the rate selection feature on a port:
Switch(config-if)# no rate selection
Related Commands
Release Modification
12.1(11)YJ This command was introduced.
Command Description
rate selection sequence Assigns a sequence on a port.
lre rate selection sequence Assigns a sequence for the entire switch.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz