Cisco Catalyst 2950 Command Reference

B-23
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Appendix B Catalyst 2950 and 2955 Switch Boot Loader Commands
set
Usage Guidelines Environment variables are case sensitive and must be entered as documented.
Environment variables are stored in files as shown in Table B-3.
The MANUAL_BOOT environment variable can also be set by using the boot manual global
configuration command.
The BOOT environment variable can also be set by using the boot system filesystem:/file-url global
configuration command.
The ENABLE_BREAK environment variable can also be set by using the boot enable-break global
configuration command.
The HELPER environment variable can also be set by using the boot helper filesystem:/file-url global
configuration command.
The CONFIG_FILE environment variable can also be set by using the boot config-file flash:/file-url
global configuration command.
The CONFIG_BUFSIZE environment variable can also be set by using the boot buffersize size global
configuration command.
The BOOTHLPR environment variable can also be set by using the boot boothlpr filesystem:/file-url
global configuration command.
The HELPER_CONFIG_FILE environment variable can also be set by using the boot helper-config-file
filesystem:/file-url global configuration command.
The PASSWD_RECOVERY environment variable can be set or reset by using the configuration CLI
service password-recovery command.
The boot loader prompt string (PS1) can be up to 120 printable characters except the equal sign (=).
Examples This example shows how to change the boot loader prompt:
switch: set PS1 loader:
loader:
You can verify your setting by using the set boot loader command.
Related Commands
Table B-3 Environment Variables Storage Location
Environment Variable Location (file system:filename)
BAUD, ENABLE_BREAK, CONFIG_BUFSIZE,
CONFIG_FILE, MANUAL_BOOT, PS1
flash:env_vars
BOOT, BOOTHLPR, HELPER, HELPER_CONFIG_FILE flash:system_env_vars
Command Description
unset Resets one or more environment variables to its previous setting.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz