Cisco Catalyst 2950 Command Reference

2-43
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
clear controllers lre log
clear controllers lre log
Use the clear controllers lre log privileged EXEC command to clear the history of link, configuration,
and timer events for a specific Long-Reach Ethernet (LRE) port or for all switch LRE ports.
clear controllers lre log [interface-id]
This command is available only on Catalyst 2950 LRE switches.
Syntax Description
Defaults No default is defined.
Command Modes Privileged EXEC
Command History
Usage Guidelines Use the clear controllers lre log command without specifying a switch LRE port to delete the history
of events on all LRE ports.
Examples This example shows how to delete the history of events on an LRE switch port:
Switch# clear controllers lre log longreachethernet0/3
You can verify that the information was deleted by entering the show controllers lre log privileged
EXEC command.
Related Commands
interface-id (Optional) ID of the LRE switch port.
Release Modification
12.1(11)YJ This command was introduced.
Command Description
logging lre Sets the LRE logging level.
show controllers lre log Displays the history of link, configuration, and timer events for a
LRE specific switch port or for all LRE switch ports.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz