Cisco Catalyst 2950 Command Reference

2-27
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
boot manual
boot manual
Use the boot manual global configuration command to enable starting the Catalyst 2950 Long-Reach
Ethernet (LRE) switch manually during the next power on cycle. Use the no form of this command to
return to the default setting.
boot manual
no boot manual
This command is available only on Catalyst 2950 LRE switches.
Syntax Description This command has no arguments or keywords.
Defaults During the next power on cycle, you cannot manually start an LRE switch.
Command Modes Global configuration
Command History
Usage Guidelines The next time you restart the system, the switch is in boot loader mode, which is shown by the
switch:
prompt. To power on the system, use the boot boot loader command, and specify the name of the
bootable image.
This command changes the setting of the MANUAL_BOOT environment variable. For more
information, see Appendix B, “Catalyst 2950 and 2955 Switch Boot Loader Commands.”
Related Commands
Release Modification
12.1(11)YJ This command was introduced.
Command Description
show boot Displays the settings of the boot environment variables.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz