EasyManuals Logo

Cisco Catalyst 2950 Command Reference

Cisco Catalyst 2950
686 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #296 background imageLoading...
Page #296 background image
2-268
Catalyst 2950 and Catalyst 2955 Switch Command Reference
0L-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
setup express
setup express
Use the setup express global configuration command to enable Express Setup mode on the switch. This
is the default setting. Use the no form of this command to disable Express Setup mode.
setup express
no setup express
This command is available only on Catalyst 2950 switches.
Syntax Description This command has no arguments or keywords.
Defaults Express Setup is enabled.
Command Modes Global configuration
Command History
Usage Guidelines When Express Setup is enabled on a new (unconfigured) switch, pressing the Mode button for 2 seconds
activates Express Setup. You can access the switch through an Ethernet port by using the IP address
10.0.0.1 and then can configure the switch with the web-based Express Setup program or the
command-line interface (CLI)-based setup program.
When you press the Mode button for 2 seconds on a configured switch, the mode LEDs start blinking.
If you press the Mode button for a total of 10 seconds, the switch configuration is deleted, and the switch
reboots. The switch can then be configured like a new switch, either through the web-based Express
Setup program or the CLI-based setup program.
Note As soon as you make any change to the switch configuration (including entering no at the beginning of
the CLI-based setup program), configuration by Express Setup is no longer available. You can only run
Express Setup again by pressing the Mode button for 10 seconds. This deletes the switch configuration
and reboots the switch.
If Express Setup is active on the switch, entering the write memory or copy running-configuration
startup-configuration privileged EXEC commands deactivates Express Setup. The IP address 10.0.0.1
is no longer valid on the switch, and your connection using this IP address ends.
The primary purpose of the no setup express command is to prevent someone from deleting the switch
configuration by pressing the Mode button for 10 seconds.
Release Modification
12.1(14)EA1 This command was introduced.

Table of Contents

Other manuals for Cisco Catalyst 2950

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 2950 and is the answer not in the manual?

Cisco Catalyst 2950 Specifications

General IconGeneral
Forwarding Bandwidth8.8 Gbps
Switching Capacity13.6 Gbps
Forwarding Rate6.6 Mpps
Weight3.6 kg
RAM16 MB
Flash Memory8 MB
Operating Humidity10% to 85% non-condensing
Uplink Ports2 x 10/100/1000Base-T
Dimensions4.4 cm x 44.5 cm x 24.2 cm
Remote Management ProtocolSNMP, Telnet, HTTP
FeaturesQuality of Service (QoS), VLAN support
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicatorssystem
Operating Temperature0 to 45°C
Ports24 x 10/100 Ethernet ports
MAC Address Table Size8, 192 entries
Power SupplyInternal 100-240V AC, 50-60Hz

Related product manuals