2-180
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
lre syslog
lre syslog
Use the lre syslog global configuration command to enable a Long-Reach Ethernet (LRE) switch to send
the switch debugging messages to the LRE logging process and to the system message logging process.
Use the no form of this command to disable the syslog export feature.
lre syslog
no lre syslog
This command is available only on Catalyst 2950 LRE switches.
Syntax Description This command has no arguments or keywords.
Defaults The syslog export feature is disabled.
Command Modes Global configuration
Command History
Usage Guidelines Before enabling the syslog export feature, follow these guidelines:
• Make sure that LRE logging is enabled.
• Make sure that the console severity in the system message logging configuration is set to debugging.
For more information, see the “Configuring System Message Logging” chapter in the software
configuration guide for this release.
In software releases earlier than Cisco IOS Release 12.1(14)EA1, the switch sends information only to
the LRE logging process. To display the LRE events, use the show controllers lre log privileged EXEC
command.
For more information, see the “Configuring LRE” chapter in the software configuration guide for this
release.
Examples This example shows how to enable the syslog export feature:
Switch(config)# lre syslog
Related Commands
Release Modification
12.1(14)EA1 This command was introduced.
Command Description
show controllers lre log Displays the history of link, configuration, and timer events for a
specific port or for all LRE switch ports.
To Next Page
Loading...
Need help?
General
