Cisco Catalyst 2950 - Page 209

2-179
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
lre sequence
This example shows the error message that appears when you try to edit a system-defined sequence:
Switch(config)# lre sequence lre-seq-complete-reach
Error:Sequence LRE-SEQ-COMPLETE-REACH is a system defined sequence. Cannot edit this
sequence
Switch>(config)#
This example shows how to delete a user-defined sequence:
Switch# configure terminal
Switch(config)# no lre sequence myseq
Switch(config-seq)# exit
Switch(config)#
Related Commands Command Description
lre rate selection sequence Assigns sequences globally.
profile (interface configuration) Adds a profile to a sequence.
profile (sequence configuration) Adds a profile to a sequence.