Cisco Catalyst 2950

2-313
Catalyst 2950 and Catalyst 2955 Switch Command Reference
0L-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
show controllers lre sequence
LRE-10-1 12.500 1.563
LRE-4 4.167 4.167
LRE-3 3.125 3.125
LRE-2 2.083 2.083
LRE-4-1 4.167 1.563
Sequence:LRE-SEQ-DOWNSTREAM Type:System-Configured
Profile Name Downstream Upstream
Rate(Mbps) Rate(Mbps)
-------------- ---------- ----------
LRE-15 16.667 18.750
LRE-15-5 16.667 6.250
LRE-15-3 16.667 3.125
LRE-15-1 16.667 1.563
LRE-10 12.500 12.500
<output truncated>
This is an example of output from the show controllers lre sequence command on the
Catalyst 2950ST-24 LRE 997 switch:
Switch# show controllers lre sequence
Global Sequence:N/A
Sequence:LRE-SEQ-COMPLETE-REACH Type:System-Configured
Profile Name Downstream Upstream
Rate(Mbps) Rate(Mbps)
-------------- ---------- ----------
LRE-12-9 12.500 9.375
LRE-12-3 12.500 3.125
LRE-9 9.375 9.375
LRE-9-6 9.375 6.250
LRE-9-4 9.375 4.688
LRE-6 6.250 6.250
LRE-6-4 6.250 4.688
LRE-9-3 9.375 3.125
LRE-4 4.688 4.688
LRE-6-3 6.250 3.125
LRE-4-3 4.688 3.125
Sequence:LRE-SEQ-DOWNSTREAM Type:System-Configured
Profile Name Downstream Upstream
Rate(Mbps) Rate(Mbps)
-------------- ---------- ----------
LRE-12-9 12.500 9.375
LRE-12-3 12.500 3.125
LRE-9 9.375 9.375
LRE-9-6 9.375 6.250
LRE-9-4 9.375 4.688
<output truncated>
Related Commands Command Description
lre rate selection sequence Assigns a rate selection sequence to the entire switch.
lre sequence Defines a user-defined sequence.