Cisco Catalyst 2950 Command Reference

2-129
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
ip access-group
Examples This example shows how to apply a numbered ACL to an interface:
Switch(config)# interface fastethernet0/1
Switch(config-if)# ip access-group 101 in
You can verify your settings by entering the show access-lists or show ip access-lists privileged EXEC
command.
Related Commands Command Description
access-list (IP extended) Defines an extended IP ACL.
access-list (IP standard) Defines a standard IP ACL.
deny (access-list configuration) Configures conditions for an IP ACL.
ip access-list Defines an IP ACL.
permit (access-list configuration) Configures conditions for an IP ACL.
show access-lists Displays ACLs configured on the switch.
show ip access-lists Displays IP ACLs configured on the switch.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz