Cisco Catalyst 2950 Command Reference

2-192
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
mac address-table notification
Examples This example shows how to enable the MAC notification feature:
Switch(config)# mac address-table notification
This example shows how to set the notification-trap interval to 60 seconds:
Switch(config)# mac address-table notification interval 60
This example shows how to set the number of entries in the history table to 32:
Switch(config)# mac address-table notification history-size 32
You can verify your settings by entering the show mac address-table notification privileged EXEC
command.
Related Commands Command Description
clear mac address-table notification Clears the MAC address notification global counters.
show mac address-table notification Displays the MAC address notification settings for all
interfaces or the specified interface.
snmp-server enable traps Sends the SNMP MAC notification traps when the
mac-notification keyword is appended.
snmp trap mac-notification Enables the SNMP MAC notification trap on a specific
interface.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz