2-232
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
pagp learn-method
Examples This example shows how to set the learning method to aggregation-port (the default):
Switch(config-if)# pagp learn-method aggregation-port
You can verify your settings by entering the show running-config or show pagp channel-group-number
internal privileged EXEC command.
Related Commands Command Description
channel-group Assigns an Ethernet interface to an EtherChannel group.
pagp port-priority Selects an interface through which all Port Aggregation Protocol (PAgP)
traffic through the EtherChannel is sent.
show pagp Displays PAgP channel-group information.
show running-config Displays the configuration information running on the switch. For syntax
information, select Cisco IOS Configuration Fundamentals Command
Reference for Release 12.1 > Cisco IOS File Management Commands >
Configuration File Commands.
To Next Page
Loading...
