Cisco Catalyst 2950 Command Reference

2-334
Catalyst 2950 and Catalyst 2955 Switch Command Reference
0L-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
show file
For this example, Table 2-19 describes the fields in the show file systems command output. Table 2-20
lists the file system types. Table 2-21 lists the file system flags.
Table 2-19 show file systems Field Descriptions
Field Description
Size(b) Amount of memory in the file system, in bytes.
Free(b) Amount of free memory in the file system, in bytes.
Type Type of file system.
Flags Permissions for file system.
Prefixes Alias for file system.
Table 2-20 File System Types
Field Description
disk The file system is for a rotating medium.
flash The file system is for a flash memory device.
network The file system is a network file system, such as TFTP, rcp, or FTP.
nvram The file system is for an NVRAM device.
opaque The file system is a locally generated pseudo file system (for example, the system)
or a download interface, such as brimux.
rom The file system is for a ROM or EPROM device.
tty The file system is for a collection of terminal devices.
unknown The file system is of unknown type.
Table 2-21 File System Flags
Field Description
ro The file system is read-only.
wo The file system is write-only
rw The file system is read/write.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz