Cisco Catalyst 2950

2-389
Catalyst 2950 and Catalyst 2955 Switch Command Reference
0L-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
show pagp
This is an example of output from the show pagp 1 internal command:
Switch> show pagp 1 internal
Flags: S - Device is sending Slow hello. C - Device is in Consistent state.
A - Device is in Auto mode.
Timers: H - Hello timer is running. Q - Quit timer is running.
S - Switching timer is running. I - Interface timer is running.
Channel group 1
Hello Partner PAgP Learning Group
Port Flags State Timers Interval Count Priority Method Ifindex
Fa0/1 SC U6/S7 H 30s 1 128 Any 16
Fa0/2 SC U6/S7 H 30s 1 128 Any 16
This is an example of output from the show pagp 1 neighbor command:
Switch> show pagp 1 neighbor
Flags: S - Device is sending Slow hello. C - Device is in Consistent state.
A - Device is in Auto mode. P - Device learns on physical port.
Channel group 1 neighbors
Partner Partner Partner Partner Group
Port Name Device ID Port Age Flags Cap.
Fa0/1 device-p2 0002.4b29.4600 Fa0/1 9s SC 10001
Fa0/2 device-p2 0002.4b29.4600 Fa0/2 24s SC 10001
Related Commands Command Description
clear pagp Clears PAgP channel-group information.
pagp learn-method Sets the source-address learning method of incoming packets received
from an EtherChannel port.