Cisco Catalyst 2950

2-392
Catalyst 2950 and Catalyst 2955 Switch Command Reference
0L-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
show parser macro
This is an example of output from the show parser macro name command:
Switch# show parser macro name standard-switch10
Macro name : standard-switch10
Macro type : customizable
macro description standard-switch10
# Trust QoS settings on VOIP packets
auto qos voip trust
# Allow port channels to be automatically formed
channel-protocol pagp
This is an example of output from the show parser macro brief command:
Switch# show parser macro brief
default global : cisco-global
default interface: cisco-desktop
default interface: cisco-phone
default interface: cisco-switch
default interface: cisco-router
customizable : snmp
This is an example of output from the show parser description command:
Switch# show parser macro description
Global Macro(s): cisco-global
Interface Macro Description(s)
--------------------------------------------------------------
Fa0/1 standard-switch10
Fa0/2 this is test macro
--------------------------------------------------------------
This is an example of output from the show parser description interface command:
Switch# show parser macro description interface fastethernet0/2
Interface Macro Description
--------------------------------------------------------------
Fa0/2 this is test macro
--------------------------------------------------------------
Related Commands Command Description
macro apply Applies a macro on an interface or applies and traces a macro on an interface.
macro description Adds a description about the macros that are applied to an interface.
macro global Applies a macro on a switch or applies and traces a macro on a switch.
macro global
description
Adds a description about the macros that are applied to the switch.
macro name Creates a macro.
show running-config Displays the current operating configuration, including defined macros. For
syntax information, select Cisco IOS Configuration Fundamentals
Command Reference, Release 12.1> File Management Commands >
Configuration File Management Commands.