Cisco Catalyst 2950 Command Reference

2-394
Catalyst 2950 and Catalyst 2955 Switch Command Reference
0L-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
show policy-map
Examples This is an example of output from the show policy-map command:
Switch> show policy-map
Policy Map bumbum
Description: this is a description.
Policy Map wizard_policy3
class wizard_1-1-1-2
set ip dscp 34
Policy Map test
Policy Map policytest
class classtest
set ip dscp 20
police 10000000 8192 exceed-action drop
This is an example of output from the show policy-map pmtimerin command:
Switch> show policy-map pmtimerin
Policy Map pmtimerin
class cmtimerin
set ip dscp 10
police 1000000 4096 exceed-action drop
class ctimerin1
police 2000000 4096 exceed-action drop
This is an example of output from the show policy-map policytest class classtest command:
Switch> show policy-map policytest class classtest
set ip dscp 20
police 10000000 8192 exceed-action drop
Related Commands Command Description
policy-map Creates or modifies a policy map that can be attached to multiple
interfaces to specify a service policy.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz