Cisco Catalyst 2950 Command Reference

2-420
Catalyst 2950 and Catalyst 2955 Switch Command Reference
0L-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
show vmps
This is an example of output from the show vmps statistics command. Table 2-32 describes each field
in the example.
Switch> show vmps statistics
VMPS Client Statistics
----------------------
VQP Queries: 0
VQP Responses: 0
VMPS Changes: 0
VQP Shutdowns: 0
VQP Denied: 0
VQP Wrong Domain: 0
VQP Wrong Version: 0
VQP Insufficient Resource: 0
Table 2-32 show vmps statistics Field Descriptions
Field Description
VQP Queries Number of queries sent by the client to the VMPS.
VQP Responses Number of responses sent to the client from the VMPS.
VMPS Changes Number of times that the VMPS changed from one server to another.
VQP Shutdowns Number of times the VMPS sent a response to shut down the port. The client
disables the port and removes all dynamic addresses on this port from the
address table. You must administratively re-enable the port to restore
connectivity.
VQP Denied Number of times the VMPS denied the client request for security reasons.
When the VMPS response denies an address, no frame is forwarded to or
from the workstation with that address. (Broadcast or multicast frames are
delivered to the workstation if the port on the switch has been assigned to a
VLAN.) The client keeps the denied address in the address table as a blocked
address to prevent further queries from being sent to the VMPS for each new
packet received from this workstation. The client ages the address if no new
packets are received from this workstation on this port within the aging time
period.
VQP Wrong Domain Number of times the management domain in the request does not match the
one for the VMPS. Any previous VLAN assignments of the port are not
changed. This response means that the server and the client have not been
configured with the same VTP management domain.
VQP Wrong Version Number of times the version field in the query packet contains a value that is
higher than the version supported by the VMPS. The previous VLAN
assignment of the port is not changed. The switches send only VMPS version
1 requests.
VQP Insufficient
Resource
Number of times the VMPS is unable to answer the request because of a
resource availability problem. If the retry limit has not yet been reached, the
client repeats the request with the same server or with the next alternate
server, depending on whether the per-server retry count has been reached.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz