Cisco Catalyst 2950

2-486
Catalyst 2950 and Catalyst 2955 Switch Command Reference
0L-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
speed
Switch(config)# interface fastethernet0/1
Switch(config-if)# speed auto 10 100
You can verify your settings by entering the show interfaces transceiver properties or the
show running-config privileged EXEC command.
Related Commands Command Description
cpe speed Sets the speed of a CPE port.
duplex Specifies the duplex mode of operation for switch ports.
show controllers lre
status
Display the status for rate selection. Use the sequence keyword to display the
status of a sequence for an LRE interface.
show interfaces Displays the administrative and operational status of all interfaces or a
specified interface.
show running-config Displays the current operating configuration. For syntax information, select
Cisco IOS Configuration Fundamentals Command Reference for
Release 12.1 > Cisco IOS File Management Commands > Configuration
File Commands.