Cisco Catalyst 2950 Command Reference

2-515
Catalyst 2950 and Catalyst 2955 Switch Command Reference
0L-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
system mtu
Examples This example shows how to set the maximum packet size to 1528 bytes:
Switch(config)# system mtu 1528
Switch(config)# exit
This example shows the response when you try to set a switch to an out-of-range number:
Switch(config)# system mtu 2000
^
% Invalid input detected at '^' marker.
You can verify your settings by entering the show system mtu privileged EXEC command.
Related Commands Command Description
show system mtu Displays the maximum packet size set for the switch.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz