Index
IN-7
Catalyst 2950 and Catalyst 2955 Switch Command Reference
78-11381-12
J
jumbo frames
displaying setting
2-411
setting switch for 2-516
L
LACP
See EtherChannel
lacp port-priority command
2-163
lacp system-priority command 2-165
Layer 2 traceroute
IP addresses
2-522
MAC addresses 2-519
line configuration mode 1-3, 1-5
Link Aggregation Control Protocol
See EtherChannel
link flap
enable error detection for
2-111
enable timer to recover from error state 2-113
link statistics, clearing 2-39
load_helper command B-13
load-distribution methods for EtherChannel 2-246
local duplex command 2-172
local speed command 2-173
logging lre command 2-174
logical interface 2-124
loopback, error recovery timer 2-113
loop guard, for spanning tree 2-452, 2-455
LRE controller, defined 2-69
lre profile command 2-175
lre rate selection command 2-46
lre rate selection sequence command 2-177
lre sequence command 2-179
lre syslog command 2-181
lre upbo command 2-182
M
mac access-group command 2-186
MAC access-list configuration mode
deny
2-86
entering 2-188
permit 2-238
mac access-list extended command 2-188
MAC ACLs
deny
2-86
permit 2-238
MAC addresses
and port security
2-502
clearing notification global counters 2-47
displaying
aging time
2-370
dynamic 2-370
multicast entries 2-373
notification setting 2-375
number of addresses 2-370
per interface 2-370
per VLAN 2-370
secure 2-396
static 2-370
dynamic
aging time
2-190
deleting 2-47
displaying 2-370
enabling MAC address notification 2-192
secure
adding
2-502
displaying 2-396
static
adding
2-194
displaying 2-370
dropping on an interface 2-196
sticky
configuring manually
2-502
enabling sticky learning 2-502
To Next Page
Loading...
