EasyManua.ls Logo

Cisco Catalyst 2950 - Page 684

Cisco Catalyst 2950
686 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Index
IN-14
Catalyst 2950 and Catalyst 2955 Switch Command Reference
78-11381-12
preventing from becoming designated 2-452
restricting which can be root 2-452
root guard 2-452
UplinkFast 2-481
root switch
affects of extended system ID
2-450, 2-484
hello-time 2-483
interval between BDPU messages 2-483
interval between hello BPDU messages 2-483
max-age 2-483
port priority for selection of 2-473
primary or secondary 2-483
switch priority 2-483
state changes
blocking to forwarding state
2-477
enabling BPDU filtering 2-442, 2-475
enabling BPDU guard 2-444, 2-475
enabling Port Fast 2-475, 2-477
enabling timer to recover from error state 2-113
forward-delay time 2-483
length of listening and learning states 2-483
shutting down Port Fast-enabled ports 2-475
state information display 2-403
VLAN options 2-470, 2-483
Switched Port Analyzer
See SPAN
switching characteristics
modifying
2-500
returning to interfaces 2-500
switchport access command 2-492
switchport block command 2-494
switchport host command 2-496
switchport mode command 2-498
switchport nonegotiate command 2-500
switchport port-security aging command 2-506
switchport port-security command 2-502
switchport priority extend command 2-508
switchport protected command 2-510
switchports, displaying 2-337
switchport trunk command 2-511
switchport voice vlan command 2-514
syslog command A-6
system mtu command 2-516
T
tar files, creating, listing, and extracting 2-12
Telnet, using with cluster switches 2-257
temperature alarms, setting A-4
test relay command A-21
traceroute, Layer 2
See Layer 2 traceroute
traceroute mac command
2-519
traceroute mac ip command 2-522
trunk ports, configuring 2-498
trunks
allowed VLANs
2-511
native VLANs 2-511
pruning-eligible VLAN list 2-513
pruning VLANs 2-511
VLAN 1 minimization 2-512
trunks, to non-DTP device 2-499
trusted boundary for QoS 2-218
type command B-24
U
UDLD
aggressive mode
2-524, 2-526
debug messages, displaying C-28
enabling globally 2-524
enabling per interface 2-526
error recovery timer 2-113
message timer 2-524
normal mode 2-524, 2-526
resetting shutdown interfaces 2-528
status 2-412

Table of Contents

Other manuals for Cisco Catalyst 2950

Related product manuals