Cisco Catalyst 2950

2-57
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
cluster commander-address
This example shows how to remove a member from the cluster by using the cluster member console:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# no cluster commander-address
You can verify your settings by entering the show cluster privileged EXEC command.
Related Commands Command Description
show cluster Displays the cluster status and a summary of the cluster to which the switch
belongs.
show running-config Displays the configuration information running on the switch. For syntax
information, select Cisco IOS Configuration Fundamentals Command
Reference for Release 12.1 > Cisco IOS File Management Commands >
Configuration File Commands.