Cisco ONS 15454 - Page 510

4-22
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
EID-3145 The RIP metric must be between 1 and 15. The Routing Information Protocol (RIP)
metric should be in the range of 1 to 15.
EID-3146 The RIP metric is invalid. Refer to the error message text.
EID-3147 An error occurred while creating the summary address. There was an error while creating the
summary address.
EID-3148 No Layer 2 domain has been provisioned. You must provision any one of the layer 2
domain.
EID-3149 The MAC addresses could not be retrieved. Refer to the error message text.
EID-3150 The target file {0} is not a normal file. The specified target file is not a normal file.
EID-3151 The target file {0} is not writable. The target file is not writeable. Specify
another file.
EID-3152 An error occurred while creating the protection group. CTC encountered an error creating
Protection Group.
EID-3153 The card cannot be deleted because it is in use. Refer to the error message text.
EID-3154 An error occurred while provisioning the card:
CTC cannot {0} the card.
CTC cannot perform the task on the card.
EID-3155 An error occurred while building the menu. CTC encountered an error building the
menu.
EID-3156 An error occurred while building the menu.
Cards were not found for the {0} group.
CTC encountered an error while building
the menu, as cards could not be found for
the specified group).
EID-3157 The selected model could not be set because of an unexpected
model class: {0}.
CTC encountered an unexpected model
class while trying to complete the task.
EID-3158 Probable causes:
- Unable to switch, because a similar or higher priority
condition exists on a peer or far-end card.
- A loopback is present on the working port.
Refer to the error message text.
EID-3159
1
An error occurred while applying the operation. CTC encountered an error while applying
this operation.
EID-3160 An error occurred while provisioning the {0}. CTC encountered the specified error.
EID-3161 An error occurred while upgrading the ring. An error was encountered while attempting
to upgrade the BLSR. Refer to the details
portion of the error dialog box for more
information.
EID-3162 This protection operation cannot be set because the protection
operation on the other side has been changed but not yet
applied.
Refer to the error message text.
EID-3163 The data in row {0} cannot be validated. CTC cannot validate the data for the
specified row.
EID-3164 The new node ID ({0}) for ring ID {1} duplicates the ID of
node {2}.
The new specified node ID for the specified
ring ID is the same as another node ID.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description