4-26
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
EID-3254 An error occurred during validation. {0} The Cisco Transport Controller (CTC) was
unable to validate the values entered by the
user, specified by {0}. This error message is
common to several different provisioning
tabs within the CTC.
EID-3255 You cannot change the timing configuration because a
Manual/Force operation is in effect.
Refer to the error message text.
WID-3256 The timing reference(s) could not be assigned because one or
more of the timing reference(s):
- is already used and/or
- has been selected twice and/or
- is attempting to use the same slot twice.
Please verify the settings.
Refer to the warning message text.
EID-3257 Duplicate DCC numbers are not permitted. {0}. CTC detected more than one occurrence of
the a DCC number. Remove one of them.
EID-3258 A software error occurred while attempting to download the
file.
Please try again later.
Refer to the error message text.
EID-3259 An error occurred while creating the FC-MR threshold. You must create a Fibre Channel Multirate
(FC_MR) card threshold.
EID-3260 An error occurred while provisioning the internal subnet:
{0}
The specified internal subnet could not be
provisioned.
EID-3261 The port rate provisioning cannot be changed while circuits
exist on this port.
Refer to the error message text.
EID-3262 The port provisioning cannot be changed when the port status
is {0}.
You must provision the ports only when the
port is Out of Service.
WID-3263 You are using Java version {0}. CTC should run with Java
version {1}. It can be obtained from the installation CD or
http://java.sun.com/j2se/
CTC is being launched with the wrong
version of the JRE {0}. This version of CTC
requires a particular version of the JRE {1}.
The CTC and browser must be closed and
restarted to allow the correct Java version to
be loaded.
EID-3265 An error occurred while modifying the protection group. Protection Group could not be modified.
EID-3266 Conditions could not be retrieved from the shelf or card view. Refer to the error message text.
WID-3267 The XTC protection group cannot be modified. Refer to the warning message text.
WID-3268 The filter entry is invalid. {0} The specified entry is invalid.
WID-3269 The {0} operation was successfully initiated for {1} but its
completion status could not be obtained from the node. When
the node is accessible, check its software version to verify if the
{0} succeeded.
Refer to the error message text.
WID-3270 The file {0} does not exist. The specified file does not exist.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description
To Next Page
Loading...
